How to Create a Wire Art Necklace

Step-by-Step Guide

1. 1

   Step 1: Prepare the wire you will use.

   Using a polishing cloth, fold over the wire portion.
   
   Pull and stretch an 18" section, or more, of wire directly from the coil pack of your crafting wire.
2. 2

   Step 2: Cut the wire into 3⁄4 inch (1.9 cm) pieces.

   Cut at least 30 such strips, depending upon your neck size.
   
   The finished necklace will measure about 18"-25"
   
   depending upon your "S" link count. , Before cutting all 30 pieces, cut one piece a little too long, measure it and bend.
   
   Measure how much extra there is once you've bent the piece and subtract that length from the original length to determine how long to cut the pieces. , Alternatively, buy them from the craft shop. , If you wish, check that all the "S" links point the same way, or alternate directions for a slightly different look.
   
   The photo shows the "S" links in alternate directions. , Create "O" ring and fish-hook type fastener for back of the neck.
   
   Or...
   
   Purchase a barrel clasp, tube magnet closure, or other style at a craft shop.
   
   A toggle clasp is a great finish, as it is easy to open and close. , Use another "O" ring or two if you need to, to get the pendant facing forward.
3. 3

   Step 3: Twist each 3⁄4 inch (1.9 cm) strip into little figure 8's

4. 4

   Step 4: or think of a "S" but keep in mind each end must be closed against the inside of the "S".

5. 5

   Step 5: Make your own "O"-shaped rings by coiling the wire around a thin rod or the tip of your pliers.

6. 6

   Step 6: Interlock your handmade "S" links by placing an "O" between them.

7. 7

   Step 7: Attach a clasp of your choice.

8. 8

   Step 8: Find the center of the chain

9. 9

   Step 9: opposite the clasp

10. 10

    Step 10: and attach any pendant you wish.

Detailed Guide

About the Author