How to Make a Finger Loop Bracelet

Step-by-Step Guide

1. 1

   Step 1: Gather your supplies.

   For this you will need 5 strands of string, each about
   2.5 feet (0.8 m) long but they all MUST be the same length.
2. 2

   Step 2: Fold all of the strings in half.

   You should fold them all in half separately and then later gather them together to avoid having them twisted together. , Attach the strings to a table with strong tape or use a safety pin and pin it to your pants. , Use your index finger, middle finger and ring finger. ,,, Once you get the hang of it, this transition should be easy. ,,,
3. 3

   Step 3: Once all the strings are gathered together

4. 4

   Step 4: tie a regular knot at the top of all the strings.

5. 5

   Step 5: Put your fingers on your left hand in 3 of the strings.

6. 6

   Step 6: With the remaining 2 strings

7. 7

   Step 7: put the strings on you middle finger and ring finger of your right hand.

8. 8

   Step 8: with palms facing the ceiling (or slightly sideways)

9. 9

   Step 9: with your index finger of your right hand

10. 10

    Step 10: take the string off of the ring finger of your left hand.

11. 11

    Step 11: you need to move the strings on your left hand down so the strings are on your middle finger and your ring finger.

12. 12

    Step 12: After that

13. 13

    Step 13: you need to grab the string off your ring finger on your right hand with your index finger on your left hand.

14. 14

    Step 14: You need to then move the strings on your right hand down to your middle finger and your ring finger.

15. 15

    Step 15: Repeat steps 6 - 9 until your bracelet is the desired length.

Detailed Guide

About the Author