How to Sew Fur Lined Mittens

Step-by-Step Guide

1. 1

   Step 1: Place one hand palm side down on the paper with your thumb slightly extended.

   Using a marker, draw a mitten-shaped outline of your hand.
   
   Leave a ½-inch space all around Also include at least 2 inches (5.1 cm) of your wrist in the outline.
   
   Cut out two. ,, Stitch along the outline starting at one side of the wrist and ending on the other side.
   
   Don’t leave the bottom of the wrist open.,, This notch will prevent the fabric in the thumb area from bunching up., Match up the pieces first, then decide where the fur goes., The fur sticking out.
   
   Pen and sew together a right hand and left hand.
   
   Repeat, then turn them inside out., Leave a ¼-inch seam.
   
   Sew the short edges together with black thread.,,
2. 2

   Step 2: Trace and cut four pieces of fleece for each hand

3. 3

   Step 3: two pieces of fake fur for each hand.

4. 4

   Step 4: Pin together two pieces of fleece

5. 5

   Step 5: a right hand and a left hand

6. 6

   Step 6: with white thread.

7. 7

   Step 7: Repeat with remaining pieces of fleece.

8. 8

   Step 8: Snip a "V”-shaped notch in the seam allowance in between the thumb and index finger.

9. 9

   Step 9: Sew fake fur on all pieces of fleece.

10. 10

    Step 10: You will have four pieces of fleece.

11. 11

    Step 11: Cut strips of black fleece long and wide enough to make a cuff around the wrist.

12. 12

    Step 12: Slip the cuff over the wrist of the mitten and align the edge of the cuff to the open end of the mitten.

13. 13

    Step 13: Sew the cuff to the wrist

14. 14

    Step 14: then flip the cuff inside out.

Detailed Guide

About the Author