How to Bleed the Brakes on an Aircooled Volkswagen Beetle

Step-by-Step Guide

1. 1

   Step 1: Assembly tools and supplies: An assistant.

   New brake fluid.
   
   A clear container partially filled with brake fluid.
   
   A length of 3/16" tubing.
   
   A box-end (usually 7mm) wrench.
   
   The stock is 7 mm; if wheel cylinders have been replaced it's possible that the valves are 1/4-inch or 5/16-inch.
2. 2

   Step 2: Ensure the brakes on all four wheels are properly adjusted.

   , If it is dirty or filled with debris, replace it with good fluid.
   
   Make sure the reservoir is filled to the horizontal seam.
   
   Reinstall the cover on both the reservoir and the bottle. , The bleeder valve is below the bolt for the wheel cylinder and above the hard brake line.
   
   It should be covered with a small rubber grommet. , Have the assistant pump the brakes slowly a few times to get pressure in the system, then depress the pedal firmly and hold it down.
   
   While the pedal is depressed, open the bleeder valve just enough to allow a flow of fluid to leave the valve.
   
   The brake pedal will sink.
   
   Watch for air bubbles to exit the end of the tube submerged in the brake fluid.
   
   Close the valve and have your assistant slowly return the brake pedal to its normal position. ,, Be sure to check the fluid level in the master cylinder reservoir frequently.,
3. 3

   Step 3: Remove the master cylinder reservoir cover and check the level and condition of the brake fluid.

4. 4

   Step 4: Begin at the wheel the furthest from the master cylinder

5. 5

   Step 5: the right rear wheel

6. 6

   Step 6: loosen the bleeder valve slightly then snug it up so it can be loosened quickly and easily.

7. 7

   Step 7: With the box wrench on the valve

8. 8

   Step 8: place one end of the tubing firmly over the bleeder valve and submerge the other end in a small quantity of brake fluid in a clear glass container.

9. 9

   Step 9: Repeat the steps until no more air bubbles appear in the container and clean bright colored fluid emerges from the valve

10. 10

    Step 10: then tighten the bleeder valve.

11. 11

    Step 11: Move to the left rear wheel

12. 12

    Step 12: then move to the right front wheel and end with the left front wheel.

13. 13

    Step 13: At the end of the operation refill the master cylinder reservoir to the horizontal seam.

Detailed Guide

About the Author