How to Change Honda Rear Disc Brake Pads

Step-by-Step Guide

1. 1

   Step 1: Drain some of the brake fluid out of master brake cylinder with a suction gun.

   Place the old fluid into an approved container and take it to an approved center to discard it. , Do this for only 1 tire at a time., Use jack stands on both sides to safely support the car., Look at your caliper., Take the caliper off the bracket., Disconnect the pad retainers and ensure the caliper pins move freely., You may have to take them to a shop to get the rotors machined or replaced if major cracks or grooves are found.,, If the groove lines up correctly, it will allow the caliper to fasten to the pads. ,, Tighten screws to the specification in your owner's manual., Repeat the process for the second set of brakes by removing the other tire.,
2. 2

   Step 2: Loosen the lug nuts on one of your rear tires with a lug wrench.

3. 3

   Step 3: Use a jack to lift your Honda vehicle's rear wheels off the ground.

4. 4

   Step 4: Remove the rear tire and set it aside.

5. 5

   Step 5: Unscrew your caliper bolts with a torque bit or Alan key that fits over the screws.

6. 6

   Step 6: Slide the brake pads and shims off the caliper.

7. 7

   Step 7: Inspect the rotor for cracks and grooves.

8. 8

   Step 8: Rub disc brake lubricant on the shims and the backs of the new brake pads and attach the shims to the pads.

9. 9

   Step 9: Turn the caliper piston clockwise so it goes back into the cylinder until the groove on the piston lines up with a tab on the inner brake pad.

10. 10

    Step 10: Apply silicon grease to the piston boot and fasten new retainers to the caliper bracket.

11. 11

    Step 11: Install the brake pad assembly and attach the bracket to the caliper.

12. 12

    Step 12: Replace the wheel and tighten the lug nuts in a star pattern.

13. 13

    Step 13: Lower the vehicle and pump the brakes to help the new pads into position.

Detailed Guide

About the Author