How to Oil Woodwork

Step-by-Step Guide

1. 1

   Step 1: Sand the wood to a smooth finish with extra fine 220 grit sandpaper.

   Tung, Linseed, Danish, Teak or Mineral oil can be used with this wood oiling technique.
   
   Mineral oil is perfect for wood projects that need to be food-safe, like cutting boards. , Make sure to rub the oil in the direction of the natural grain of the wood.
   
   Rub hard to work the oil well into the wood. ,,,,,, This helps to push the oil deep into the pores and really starts to enhance the appearance of the wood's natural grain. ,,,, Just make sure to remove any excess oil and allowing the wood to dry for 24 hours between each coat.
   
   It may take several days for the oil to cure completely.
2. 2

   Step 2: Apply a liberal amount (unless you're using Danish oil

3. 3

   Step 3: which needs to be applied conservatively so the wood can soak it all up)of oil directly to a small section of your wood.

4. 4

   Step 4: Rub the oil into the wood with a clean

5. 5

   Step 5: dry soft cloth.

6. 6

   Step 6: Continue this process until all the wood is covered.

7. 7

   Step 7: Let the oil stay on the wood for approximately 30 minutes.

8. 8

   Step 8: Remove any excess oil from the wood with a dry cloth.

9. 9

   Step 9: Allow the wood to stand for at least 24 hours.

10. 10

    Step 10: Pour a liberal amount of oil onto a piece of 600 to 800 grit wet-and-dry sandpaper.

11. 11

    Step 11: Work the oil into the wood again using the sandpaper.

12. 12

    Step 12: Repeat this process until you've covered the entire surface of the wood with the oiled sandpaper.

13. 13

    Step 13: Wipe off any excess oil from the wood with dry cloth.

14. 14

    Step 14: Allow to stand for another 24 hours.

15. 15

    Step 15: Repeat the sandpaper finish as many times as you like

16. 16

    Step 16: until the desired luster is achieved.

Detailed Guide

About the Author