How to Start the Engine of a Cessna

Step-by-Step Guide

1. 1

   Step 1: Mixture Rich - Push the mixture knob in fully allowing maximum amount of fuel into engine.

   heat knob in fully. ,, If the engine is cold priming may be necessary before the engine will start.
   
   To prime simply pull out of the priming knob and push it back in.
   
   Repeat this step two or three times as needed. , NOTE: you may use your eye for this step; it does not have to be exactly 1/4 of an inch. ,, Hold it in this position until the engine has fully started. ,
2. 2

   Step 2: Carburetor Heat Cold - Push the carburetor.

3. 3

   Step 3: Master Switch On - Turn the master switch in the upward position.

4. 4

   Step 4: Prime as required - In summer or when engine is already warm there is no need to prime.

5. 5

   Step 5: Throttle open 1⁄4 inch (0.6 cm) - Push the throttle in toward the control panel 1/4 of an inch.

6. 6

   Step 6: Propeller Blast area clear - Make sure there is no one behind you before starting the engine.

7. 7

   Step 7: Ignition Switch to start - Turn the key all the way to the right.

8. 8

   Step 8: Begin pre-take off check list.

Detailed Guide

About the Author