How to Build a Stone Foundation
Dig a perimeter trench along the boundaries of your proposed building., Set in the largest stones first., Pack it tight., Cover with gravel, and tamp., Lay any pipe or conduit down and pack around it with stone., Put in the stem wall of your choice...
Step-by-Step Guide
-
Step 1: Dig a perimeter trench along the boundaries of your proposed building.
The trench should be about
1.5' wide, and deep enough so that it's below the frostline.
Use a pick/mattock to break up the soil, and a transfer shovel to shovel it out.
The soil can be used as fill to build up the grade within the foundation, or outside it to slope the land down and away from the dwelling.
When the trench depth is roughed out, use a square-ended shovel to scrape the bottom, so that the floor of the trench remains packed and undisturbed. -
Step 2: Set in the largest stones first.
If you have boulders, or something like these hardened Quikrete bags to use, lay them in the bottom of the trench like this:
Continue to set in the largest stones you can lift and fit in the trench.
The stone should get progressively smaller as you fill towards the top. , Everything should fit like a puzzle
- pound rocks in with a hammer where you need to.
Urbanite can also be used, and torn up asphalt sections from roads.
If you're using old concrete block, break it up into flat pieces with a hammer. , Make sure to swish the gravel around with your hands into all the crevices in your rubble. , For good measure, lay an extra water line, and both 2" to 3" greywater and 4" blackwater pipe, just in case you want to tie into them at some point. , If you want to continue in the same low-cost, green, site-harvested, ultra-durable tradition, do an earthbag stem wall.
This is rows of polypro seed bags filled with either dirt or rock, with strips of barbed wire run between each row for tensile strength.
In the standard earthbag stem wall the bottommost rows are composed of bags of tamped aggregate (sand, gravel, rock, etc.), and the rows above are filled with a stabilized earth mix
- your dirt mixed with either cement or lime, and allowed to cure until it hardens into rock.
The stem wall when finished is covered in chicken wire and plastered for lateral strength and to protect the polypro bags.
Earthbags are wide and make excellent stem walls for alternative building systems such as cordwood masonry and straw bale
- as well as walls of earthbags themselves! -
Step 3: Pack it tight.
-
Step 4: Cover with gravel
-
Step 5: and tamp.
-
Step 6: Lay any pipe or conduit down and pack around it with stone.
-
Step 7: Put in the stem wall of your choice
-
Step 8: to keep your building high off the ground.
Detailed Guide
The trench should be about
1.5' wide, and deep enough so that it's below the frostline.
Use a pick/mattock to break up the soil, and a transfer shovel to shovel it out.
The soil can be used as fill to build up the grade within the foundation, or outside it to slope the land down and away from the dwelling.
When the trench depth is roughed out, use a square-ended shovel to scrape the bottom, so that the floor of the trench remains packed and undisturbed.
If you have boulders, or something like these hardened Quikrete bags to use, lay them in the bottom of the trench like this:
Continue to set in the largest stones you can lift and fit in the trench.
The stone should get progressively smaller as you fill towards the top. , Everything should fit like a puzzle
- pound rocks in with a hammer where you need to.
Urbanite can also be used, and torn up asphalt sections from roads.
If you're using old concrete block, break it up into flat pieces with a hammer. , Make sure to swish the gravel around with your hands into all the crevices in your rubble. , For good measure, lay an extra water line, and both 2" to 3" greywater and 4" blackwater pipe, just in case you want to tie into them at some point. , If you want to continue in the same low-cost, green, site-harvested, ultra-durable tradition, do an earthbag stem wall.
This is rows of polypro seed bags filled with either dirt or rock, with strips of barbed wire run between each row for tensile strength.
In the standard earthbag stem wall the bottommost rows are composed of bags of tamped aggregate (sand, gravel, rock, etc.), and the rows above are filled with a stabilized earth mix
- your dirt mixed with either cement or lime, and allowed to cure until it hardens into rock.
The stem wall when finished is covered in chicken wire and plastered for lateral strength and to protect the polypro bags.
Earthbags are wide and make excellent stem walls for alternative building systems such as cordwood masonry and straw bale
- as well as walls of earthbags themselves!
About the Author
Sophia Nguyen
Sophia Nguyen specializes in architecture and design and has been creating helpful content for over 2 years. Sophia is committed to helping readers learn new skills and improve their lives.
Rate This Guide
How helpful was this guide? Click to rate: