How to Build a Gundam

Step-by-Step Guide

1. 1

   Step 1: Remove all sheets from individual packaging.

   Also allow 10 minutes for ink to dry before beginning construction.
   
   If you make an error you can either use a pencil eraser to remove the mistake or use some very fine sandpaper. ,,, (Be careful not to mix up parts!) , Possible errors may still occur at this point and will need to be reworked before hand.
   
   Now is also the best time to apply additional stickers or any other post construction detail. , and then carefully peel away the tape.
   
   For any air bubbles just push them out with a cotton ball or cut them out. ,
2. 2

   Step 2: Place sheets in alphabetical order.

3. 3

   Step 3: If you plan on doing detailed ink work it is best to do so before clipping out individual pieces.

4. 4

   Step 4: Use either a nail clipper to get rid of the nubs

5. 5

   Step 5: or a sprucing knife for a more fine job.

6. 6

   Step 6: Refer to the instructions and follow them page by page.

7. 7

   Step 7: When asked to construct a leg or arm consider building 2 at the same time for smoother progress.

8. 8

   Step 8: Refrain from attaching appendages before final model completion.

9. 9

   Step 9: When applying etching sticker

10. 10

    Step 10: you must cut out the sticker with a sprucing knife(anything works but sprucing knives are easier to work with)

11. 11

    Step 11: tape on the sticker with clear tape

12. 12

    Step 12: and then etch away

13. 13

    Step 13: with a blunt hard object.

14. 14

    Step 14: Finished.

Detailed Guide

About the Author