How to Fix Stainless Steel Scratches with Scratch‐B‐Gone
Prepare the Restoration area., Attach a pad to the grip handle., Keep your fingers away from the clamps., Shake bottle well.
Step-by-Step Guide
-
Step 1: Prepare the Restoration area.
Use painter’s tape to seal off all decorative logos, letters, decals, insignias, intersecting grains, countertops, or frames that are in close proximity to the restoration area. -
Step 2: Attach a pad to the grip handle.
Place the chosen pad on a clean flat surface (review chart, Pad Abrasiveness and Usage.
Place grip handle in middle of pad.
Pull up one of the two clip levers to open side clamps.
Tuck one end of pad under clamps.
Slowly and carefully lower clip lever to lock pad securely into place. , Letting go of clip lever prematurely may result in injury.) Slowly release clamp to lock position.
Repeat on other side of handle.
Pad is secured when stretched tightly along grip base.
The Grip handle can be used horizontally or vertically as long as your pad strokes follow the direction of the grain. , Apply small amount to pad in an “S” pattern.
Keep just enough ULTRA SHINE on pad to maintain cutting effectiveness during restoration process.
ULTRA SHINE leaves surfaces dry to the touch upon wiping.
Do not use ULTRA SHINE on 1” x 6” Finger Strip.
Tightly secure bottle cap on unused ULTRA SHINE and store in a cool dry place. -
Step 3: Keep your fingers away from the clamps.
-
Step 4: Shake bottle well.
Detailed Guide
Use painter’s tape to seal off all decorative logos, letters, decals, insignias, intersecting grains, countertops, or frames that are in close proximity to the restoration area.
Place the chosen pad on a clean flat surface (review chart, Pad Abrasiveness and Usage.
Place grip handle in middle of pad.
Pull up one of the two clip levers to open side clamps.
Tuck one end of pad under clamps.
Slowly and carefully lower clip lever to lock pad securely into place. , Letting go of clip lever prematurely may result in injury.) Slowly release clamp to lock position.
Repeat on other side of handle.
Pad is secured when stretched tightly along grip base.
The Grip handle can be used horizontally or vertically as long as your pad strokes follow the direction of the grain. , Apply small amount to pad in an “S” pattern.
Keep just enough ULTRA SHINE on pad to maintain cutting effectiveness during restoration process.
ULTRA SHINE leaves surfaces dry to the touch upon wiping.
Do not use ULTRA SHINE on 1” x 6” Finger Strip.
Tightly secure bottle cap on unused ULTRA SHINE and store in a cool dry place.
About the Author
Samuel Murphy
Enthusiastic about teaching DIY projects techniques through clear, step-by-step guides.
Rate This Guide
How helpful was this guide? Click to rate: