How to Glue Wood Together

Step-by-Step Guide

1. 1

   Step 1: Decide if your project is right for normal white glue.

   White glue is best for indoor projects that have a low to moderate amount of wear.
   
   White glue is also preferred for smaller craft projects rather than furniture.
   
   If your wood project will be used regularly or is large, move on to the next method, using yellow carpenter’s glue.
2. 2

   Step 2: Purchase a white

   Children’s glues are usually watered down for safety. , Be sure to apply it to one side of the entire edge that will be glued. , Placing it near the edge of your table will make it easier to clamp. , Cover these scrap pieces in contact paper or tape to keep them from sticking to your wood. , Screw clamps are best with larger projects. , Resist the temptation to wipe it up with a wet cloth, since it can dilute the glue.
   
   Instead wipe it with a dry cloth or sand it off later. ,
3. 3

   Step 3: polyvinyl acetate glue that is not meant for children’s use.

4. 4

   Step 4: Apply the white glue to the edge or joint of your piece with a small paintbrush.

5. 5

   Step 5: Affix the joint or wood pieces together on a worktable or craft surface.

6. 6

   Step 6: Place the wood between two scrap pieces of wood.

7. 7

   Step 7: Use screw clamps

8. 8

   Step 8: C-clamps or spring clamps.

9. 9

   Step 9: Screw the clamps into place and allow excess glue to press out of the areas where the wood pieces meet.

10. 10

    Step 10: Clamp for at least two hours

11. 11

    Step 11: but give most projects overnight to cure.

Detailed Guide

About the Author