How to Install a Factory Navigation Radio Into a 2002 2004 Jeep Grand Cherokee

Step-by-Step Guide

1. 1

   Step 1: Start by using a pry tool to pry the radio bezel surrounding your Jeep's factory radio out from the dashboard.

   Set it aside, you'll need it later. , Remove them and set them aside, you'll need them later., You'll be reinstalling it later., Set your Jeep's factory radio aside.,,,, The wiring harnesses and CD changer cable should snap securely into place.
   
   Plug the GPS navigation antenna into the back of the RB1 navigation radio.,, You have successfully completed the installation process!
2. 2

   Step 2: Your Jeep's factory radio is held in by four (4) Philips-head screws.

3. 3

   Step 3: Remove the dashboard tweeter bezel by using a pry tool and set it aside.

4. 4

   Step 4: Remove your Jeep's factory radio from the dashboard and disconnect the wiring harnesses

5. 5

   Step 5: CD changer cable

6. 6

   Step 6: and radio antenna.

7. 7

   Step 7: Run the wiring plug from the GPS navigation antenna down through your Jeep's dashboard and pass it through to the opening in the dashboard for the radio.

8. 8

   Step 8: Reinstall the dashboard tweeter bezel and gently press down on it to secure it into place.

9. 9

   Step 9: Peel back the sticky pad on the back of the GPS navigation antenna and stick the GPS navigation antenna onto the driver's side of the dashboard tweeter bezel

10. 10

    Step 10: right in the center near the windshield.

11. 11

    Step 11: Plug the wiring harnesses

12. 12

    Step 12: CD changer cable

13. 13

    Step 13: and radio antenna into your RB1 navigational radio.

14. 14

    Step 14: Secure your RB1 navigational radio into your Jeep's dashboard by securing the four (4) Philips-head screws you removed earlier.

15. 15

    Step 15: Finally

16. 16

    Step 16: complete the installation by re-securing the radio bezel and pressing gently to secure it.

Detailed Guide

About the Author