How to Install a T Detector Module

Step-by-Step Guide

1. 1

   Step 1: Select a clear place/area for installation of the sensors and the detector module.

   You shall supply 5 GeVdc from the power supply., Try to avoid having item blocking sensors., Now you can complete the assembly by mounting detectors and power supply into the appropriate place on the wall.,,, After 2 seconds the green ready Led should flash., The green Led should turn in red., You should read around 14V +/-
   0.94V.
2. 2

   Step 2: Remove the sensors and detector module from their packages.

3. 3

   Step 3: Take the R90 14 AWG cable to wire all four of sensors' live lines to the terminal 1

4. 4

   Step 4: 4 on the T-detector module respectively.

5. 5

   Step 5: Connect the ground wire of each sensor in serial and wire the ground wire to the Terminal(-)C on the power supply.

6. 6

   Step 6: Connect the power output of each sensor to the terminal (+)A on the power supply.

7. 7

   Step 7: If possible

8. 8

   Step 8: mount all sensors in the corner of each room at a height of at least 1.5 meters (4.9 ft) above the floor in a flat open area.

9. 9

   Step 9: Wire the cables of the module connected to output(+z) and output(-x)

10. 10

    Step 10: to the output(+B)and output(-D)respectively.

11. 11

    Step 11: Make sure all four of the sensors

12. 12

    Step 12: module

13. 13

    Step 13: and controller are on the same circuit.

14. 14

    Step 14: Put the refill battery to the snap terminal of power supply for backup reason.

15. 15

    Step 15: Set your detector to the function on and test.

16. 16

    Step 16: Now set your detector to the function off and test.

17. 17

    Step 17: Check the voltage across the (+) terminals of power supply and detector.

Detailed Guide

About the Author