How to Install a Vinyl Graphic

Step-by-Step Guide

1. 1

   Step 1: Clean the surface.

   The surface should be non porous for the most favorable results.
   
   A primed or flat finish will also be a problem if quality is intended.
   
   The surface should be clean and dust free.
   
   Using a low grade detergent.
   
   Be sure the detergent will not have ammonia in it, window cleaner has a poor application and drying time.
2. 2

   Step 2: Measure the area you will be applying the decal or graphic.

   Take into consideration any contours, bends and moldings. , Make sure you keep the markings away from the area of application and use the marks a guide only. ,, This is done by finding the area to be applied and hold it firmly in place, take a piece of masking tape and tape across the top of the graphic so when you lift it up it will lay back down to the original position. ,, Remove the masking from the graphics.
3. 3

   Step 3: Mark the measured area using a grease pencil.

4. 4

   Step 4: Layout the graphic on the area it is to be applied too.

5. 5

   Step 5: Create a hinge with masking tape.

6. 6

   Step 6: Lift up the graphic and wet the area the graphic is to be applied

7. 7

   Step 7: carefully peel off the back from the graphic and working down from the top of the graphic

8. 8

   Step 8: squeegee down working the air bubbles and wetting solution out.

9. 9

   Step 9: Wipe off excess wetting solution and be sure the graphic is well adhered.

Detailed Guide

About the Author