How to Install Bidet Bidan for Disabled

Step-by-Step Guide

1. 1

   Step 1: Bidan as supplied is ready to be installed on the existing toilet.

   It is equipped with a two ways T-joint and adaptor, which are to be connected to the standard flushing tank (in the case of absence outside flushing tank, i.e. it is in the wall inside,
   - call for installer/plumber to make additional water faucet for Bidan).
   
   This T-joint assures the supply of water both to the flushing tank and the Bidan simultaneously.
2. 2

   Step 2: Connection to the lavatory pan:

   ,, The screws have to be inserted through the half-rounded holes on the bottom of the Bidan box and fasten the Bidan with nuts onto the pan. ,,,,,,,,,, Open the Bidan faucet and let water go through steadily for several minutes.
   
   Then, switch on the main button (green light will appear) and water will warm up at 5-7 seconds to maintain a permanent lukewarm temperature, controlled by the black round button with numbers.
   
   It is our recommendation, that after having used the Bidan, to disconnect it from the electricity supply by simple switching off the main green button.
3. 3

   Step 3: Take off the existing seat and cover.

4. 4

   Step 4: Place the Bidan on the lavatory pan and connect it with the 2 plastic screws

5. 5

   Step 5: which you will find in the accessories bag.

6. 6

   Step 6: Connection of Bidan to water supply:

7. 7

   Step 7: Shut the water supply to the flushing tank.

8. 8

   Step 8: Unscrew the pipe from the flushing tank or from the water supply faucet (according to local construction of the toilet).

9. 9

   Step 9: Attach the two ways T-joint to the water supply inlet and place a rubber washer on each arm of the T-joint.

10. 10

    Step 10: Connect the Bidan water supply pipe to the lower opening of the T-joint.

11. 11

    Step 11: Connect the main water supply pipe to the free opening of the T-joint.

12. 12

    Step 12: Reopen the water supply faucet to the flushing tank.

13. 13

    Step 13: In the areas of high water pressure please adjust the Bidan faucet to your comfort level during use.

14. 14

    Step 14: Connection of Bidan to electricity supply:

15. 15

    Step 15: Only after having completed the above instructions

16. 16

    Step 16: connect the Bidan plug to the electricity supply (in the case of absence a plug in the toilet

17. 17

    Step 17: call to the local electrician to add it).

Detailed Guide

About the Author