How to Install Hurricane Shutters

Step-by-Step Guide

1. 1

   Step 1: Pull out the parts and lay them out on your driveway or lawn near the window they will be protecting.

   Each part should come numbered and pre-drilled.
2. 2

   Step 2: Place the top track above the top of the window.

   Level and mark your wall to line up with the pre-drilled hole(s). , The ends of these screws should remain out until the sides are put on.
   
   Make sure the track is level. , Adjust the curtains as needed so they are away from the edges.
   
   Each wheel assembly should be marked left or right. , Check that the panel is straight and flush with the top piece.
   
   The smaller part of the side panel should face inward toward the window. , Insert the bushings at the back of the curtains into the grooves on the bottom track. ,,,
3. 3

   Step 3: Attach this part with 2.25-inch (57.150 mm) concrete anchors and screws.

4. 4

   Step 4: Position the wheels into the top and make sure the pins face the outside.

5. 5

   Step 5: Attach one side panel with 2.25-inch (57.150 mm) concrete anchors and screws.

6. 6

   Step 6: Fasten the bottom panel with the same-sized concrete anchors and screws.

7. 7

   Step 7: Affix the start strips of the curtains to the side panels with the screws provided.

8. 8

   Step 8: Check that the sides of the accordion close and lock properly.

9. 9

   Step 9: Caulk around the sides of your accordion shutters

10. 10

    Step 10: if desired.

Detailed Guide

About the Author