How to Install Scion FR S OEM Fog Lights

Step-by-Step Guide

1. 1

   Step 1: Using a trim removal tool or any flat plastic edge

   Remove these three (3) clips and pull back the fender liner. , Connect the harness to the fog light. , Use the supplied hardware to mount the screw into the bumper with a Phillips head screwdriver. , And repeat the same steps for the other side. ,, With this knowledge, connect the red wire from the switch to this power source (you may have to extend the wires for it to reach).
   
   Doing this will allow you to only turn on the fog lights only if the vehicle is on to prevent you from accidentally leaving them on if you are not using the car.
   
   For an easy installation, you can directly connect the white wire to the desired fuse slot so whenever the vehicle is on, the fog lights will automatically turn on with it. ,
2. 2

   Step 2: carefully remove the factory bezel starting from the top.

3. 3

   Step 3: On the side that you are working on

4. 4

   Step 4: turn the wheels towards the opposite direction to expose the three (3) clips that hold the fender liner on.

5. 5

   Step 5: Using the supplied harness

6. 6

   Step 6: route one of the H11 plugs down towards the fog light area.

7. 7

   Step 7: Install the fog light assembly by first locking in the two tabs on the right into the factory bumper.

8. 8

   Step 8: Install the fog lamp bezel trim over the newly installed fog light assembly.

9. 9

   Step 9: Connect the relay harness positive and negative wires to the car battery directly.

10. 10

    Step 10: Open up your fuse box and use a test light to find out which open fuse slot provides power when the vehicle is on.

11. 11

    Step 11: Enjoy your new factory fit Scion FR-S Fog Lamps!

Detailed Guide

About the Author