How to Install Support Package for Raspberry Pi in MATLAB

Step-by-Step Guide

1. 1

   Step 1: Select the installation option.

   There are two ways to do this:
   Either in the Command window of MATLAB, type supportPackageInstaller Or you can choose on the MATLAB menu item, "Get Hardware Support Packages".
2. 2

   Step 2: Choose Install from Internet.

   , Hold SHIFT to choose two options. ,, The picture in the MATLAB window shows the network configuration later used, so don't connect Raspberry Pi to your PC at this time. , This step is to install the firmware onto an SD card. ,,, The PWR LED should be on and the OK LED should blink. , You can press "Test Connection" to check if the connection is successful.
3. 3

   Step 3: Look for Raspberry Pi package and install MATLAB (and Simulink version if needed later).

4. 4

   Step 4: In the "Support package for"

5. 5

   Step 5: choose Raspberry Pi.

6. 6

   Step 6: Choose “Direct connection to host computer”.

7. 7

   Step 7: Insert the SD card to your PC

8. 8

   Step 8: make sure you're choosing the correct SD card drive.

9. 9

   Step 9: Insert the SD card to Raspberry Pi board.

10. 10

    Step 10: Connect the Raspberry Pi board with PC by an Ethernet cable

11. 11

    Step 11: Plug in the adapter to Raspberry Pi board and connect to it the power source.

12. 12

    Step 12: Wait for a window to appear showing the connection is successful.

Detailed Guide

About the Author