How to Maintain a Pro Lift F Series Hydraulic Floor Jack

Step-by-Step Guide

1. 1

   Step 1: Secure the object being lifted.

   Ensure that the load that is to be lifted has been properly secured to prevent inadvertent movement during the lifting process.
2. 2

   Step 2: Close the release valve

   Locate and close the release valve by turning it fully clockwise.
   
   Remove the handle from the handle sleeve.
   
   CAUTION! Do not over-tighten when closing the Release Valve as damage to the threads and seals may result. , Center the saddle under the proper designated lift-point. , Insert the handle into the handle sleeve and begin pumping the saddle up to the lift-point. ,, Pump the Handle until the load reaches the desired lift height. , Immediately transfer the lifted load to appropriately-rated jack stand(s).
3. 3

   Step 3: using the handle.

4. 4

   Step 4: Position the jack saddle.

5. 5

   Step 5: Raise the jack to lift the object at the point.

6. 6

   Step 6: Re-verify the lift-point

7. 7

   Step 7: saddle position

8. 8

   Step 8: and proper base support for the jack itself to insure a safe lift.

9. 9

   Step 9: Lift the load to it's desired height.

10. 10

    Step 10: Transfer the load to the jack stand.

Detailed Guide

About the Author