How to Make a Duct Tape PSP Skin

Step-by-Step Guide

1. 1

   Step 1: Rip a strip of duct tape (in the color of your choice) that is long enough to fit on the back of your PSP and cover all the buttons.

   Flip it so the sticky side is facing you.
2. 2

   Step 2: Get another strip that is the same size as the first.

   Lay this one halfway down, sticky side down on top of the first one. , Fold the sticky parts at the top and the bottom of the sheet. , Mark where the buttons (and power switch) will be. , You can also use scissors, but it will be much more complicated.
   
   Remember that the holes can be bigger than the buttons (and probably should be). ,, Both sides should be sticky.
   
   You can make a skinny one by taking one strip of duct tape, cutting it in half, and folding the edges so the tips have non-sticky parts on them. ,, For the skinny strips, place them on the sides that have the button holes.
   
   Pull the wings tight and stick them onto the PSP. ,
3. 3

   Step 3: Keep doing this until you have a "sheet" of duct tape long enough to cover the back of your PSP

4. 4

   Step 4: the top edges

5. 5

   Step 5: and the sides with the buttons.

6. 6

   Step 6: Once you have the sheet

7. 7

   Step 7: get a sharpie.

8. 8

   Step 8: Using a craft knife or X-ACTO knife

9. 9

   Step 9: cut out where the buttons will be.

10. 10

    Step 10: Fold your sheet of duct tape over the PSP on all the desired areas of application to make sure that nothing has gone wrong and that the button holes are in the right place.

11. 11

    Step 11: To stick the skin onto the PSP

12. 12

    Step 12: make four strips

13. 13

    Step 13: two broad and two skinny

14. 14

    Step 14: and make them double sided.

15. 15

    Step 15: For the broad strips

16. 16

    Step 16: cut out two separate strips instead of cutting one.

17. 17

    Step 17: Place the two broad strips to stick to the back of the PSP.

18. 18

    Step 18: Show off your new PSP skin!

Detailed Guide

About the Author