How to Repair a Vornado Tower Fan or Heater Rattle Noise

Step-by-Step Guide

1. 1

   Step 1: Remove the first sets of screws.

   Remove two sets of four screws from the base plate.
   
   Remove the four larger screws from the floor pedestal.
   
   Remove the four smaller screws from the bottom of the fan assembly.
2. 2

   Step 2: Lay the unit on its side with the control panel on your left.

   Remove the two larger screws from the left side of the unit.
   
   Remove the three remaining cage guard screws. , To do so, pull the back of the unit towards the front and upwards, lifting the access cover off. , Loosen this and position it 1mm above the circlip. , Do not over tighten, but take all play out of the screws. ,,
3. 3

   Step 3: Expose the squirrel cage fan assembly.

4. 4

   Step 4: Locate the locking collar screw on the shaft.

5. 5

   Step 5: Tighten the screws holding the shaft bearings with hand force (2-3 fingers or 8-10ft/lbs).

6. 6

   Step 6: Do this for the motor mount screws and any exposed screws

7. 7

   Step 7: and reassemble.

8. 8

   Step 8: You should now have a like-new whisper quiet Vornado!

Detailed Guide

About the Author