How to Test a Detox Foot Bath
Separate the wires about 15 inches (38 cm) and strip them about 6 inches (15 cm) each., Wrap the exposed wire around each spoon., Fill your dishpan with warm water and two heaping tablespoons of Epsom salt. , Put the spoons in the salt water, then...
Step-by-Step Guide
-
Step 1: Separate the wires about 15 inches (38 cm) and strip them about 6 inches (15 cm) each.
If you've never stripped a wire, be careful not to cut all the way through. -
Step 2: Wrap the exposed wire around each spoon.
Secure with plumbing tape to keep water out. ,, You will see "toxic" substances released in about 90 seconds, and your feet aren't even in there! , Don't bother putting your feet in.
If done improperly, there's the possibility of electrocution, and even if done properly, there's a chance of metals leaching into your body--see Warnings below. -
Step 3: Fill your dishpan with warm water and two heaping tablespoons of Epsom salt.
-
Step 4: Put the spoons in the salt water
-
Step 5: then plug in the transformer.
-
Step 6: Unplug the transformer and dump the water.
Detailed Guide
If you've never stripped a wire, be careful not to cut all the way through.
Secure with plumbing tape to keep water out. ,, You will see "toxic" substances released in about 90 seconds, and your feet aren't even in there! , Don't bother putting your feet in.
If done improperly, there's the possibility of electrocution, and even if done properly, there's a chance of metals leaching into your body--see Warnings below.
About the Author
Joseph Reynolds
Brings years of experience writing about hobbies and related subjects.
Rate This Guide
How helpful was this guide? Click to rate: