How to Make a Bottle Cap Party Whistle
Take an empty aluminum drink can., Use a pair of scissors to make some strategic cuts. , Take the sheet of aluminum foil., Cut along narrow strip from the sheet metal., Then cut the smaller stubbier piece as well., Join these pieces together, the...
Step-by-Step Guide
-
Step 1: Take an empty aluminum drink can.
Make sure you save at least 2 tabs. , Make sure the edges are straight as possible. , The long strip is for the single can tab, while the smaller is a wide. ,,, We now formed the mouthpiece for our whistle. , Be careful, not to bend it. ,,, Make sure the two bottoms are lined up. ,, Then fit the barrel inside one of the caps. ,,,,,,, And now we already made a whistle with the used of empty drink can.
You can add yard to make the whistle fully accessible anytime you want. -
Step 2: Use a pair of scissors to make some strategic cuts.
-
Step 3: Take the sheet of aluminum foil.
-
Step 4: Cut along narrow strip from the sheet metal.
-
Step 5: Then cut the smaller stubbier piece as well.
-
Step 6: Join these pieces together
-
Step 7: the smaller rectangle centered on top.
-
Step 8: Wrap around the back holding it in place and snip the top corners off.
-
Step 9: Fold the tab over to lock everything together.
-
Step 10: Grab the other end of the strip and push it back through the mouthpiece.
-
Step 11: The bottle cap.Get 2 clean bottle caps.
-
Step 12: Use the scissors
-
Step 13: snip the sides of the caps.
-
Step 14: Cut a little notch in each caps.
-
Step 15: Form a round container with a symmetrical hole at the top.
-
Step 16: The final product.Get the aluminum drink can that you made earlier.
-
Step 17: Put some hot -glue inside the caps.
-
Step 18: Then placed the rounded strip back in position
-
Step 19: Carefully
-
Step 20: cut the strip so it lines up the top of the notch.
-
Step 21: Pull the scrap part out of the mouthpiece.
-
Step 22: Add the hot-glue to other cap.
-
Step 23: Press the two firmly together.
-
Step 24: Cut one of the tabs in half and hot –gluing it to the back.
Detailed Guide
Make sure you save at least 2 tabs. , Make sure the edges are straight as possible. , The long strip is for the single can tab, while the smaller is a wide. ,,, We now formed the mouthpiece for our whistle. , Be careful, not to bend it. ,,, Make sure the two bottoms are lined up. ,, Then fit the barrel inside one of the caps. ,,,,,,, And now we already made a whistle with the used of empty drink can.
You can add yard to make the whistle fully accessible anytime you want.
About the Author
Jerry Peterson
Writer and educator with a focus on practical crafts knowledge.
Rate This Guide
How helpful was this guide? Click to rate: