How to Make a Princess Hat Pinata

Step-by-Step Guide

1. 1

   Step 1: Cut the posterboard into 1/4 of a circle

   Staple or tape to form a cone.
   
   Trim the bottom of the cone to make it flat when sitting on the table.
2. 2

   Step 2: then bring the two sides together.

   , You'll have to make a hole through the crepe paper that matches the holes in the posterboard. ,, Each crepe paper should wind in opposite directions, crossing on the front and back side of the cone, each time around.
   
   Wind all the way to the bottom. ,,, You will only need about 4 pieces of tape. , Put a bow over each piece of tape.
   
   Put a bow at the top of the pinata as well. , Put some twine through the holes near the top to hang your pinata.
3. 3

   Step 3: Punch two small holes about 3 inches (7.6 cm) from the top of the cone (the string for hanging the pinata will go here).

4. 4

   Step 4: Cover the cone with a large sheet of pink crepe paper and tape in place.

5. 5

   Step 5: Fold up the bottom ends inside the cone and tape in place.

6. 6

   Step 6: Wrap two strands of purple crepe paper around the cone

7. 7

   Step 7: beginning from the top.

8. 8

   Step 8: Glue a sequin to each crossing of the streamers.

9. 9

   Step 9: Fill the hat with candy.

10. 10

    Step 10: Cover the plastic plate with pink crepe paper and tape to the bottom of the hat.

11. 11

    Step 11: Use hot glue to attach bows made from pink and purple crepe paper streamers near the bottom of the cone.

12. 12

    Step 12: It's ready.

Detailed Guide

About the Author