How to Mod an Xbox 360 Controller
Take apart your Xbox 360 Controller., Keep your screws in sight!, Get the green circuit board., Solder a wire onto the middle pin and the other end of the wire to your button., Attach your button.
Step-by-Step Guide
-
Step 1: Take apart your Xbox 360 Controller.
You will need a Safety-TORX screwdriver to do so or a flat headed screwdriver.
There are 7 screws in total. 6 visible, another, hidden behind a sticker near the bottom under the battery pack.
Carefully take the front off the controller and set the buttons and other things down somewhere. -
Step 2: Keep your screws in sight!
If you lose them you can't put your controller back together. , Look to the far right. there should be three little silver pins; one on top another in a line. , Be careful not to get the solder on the circuit board.
This could cause problems with the controller. , This only works with some guns and increases accuracy. -
Step 3: Get the green circuit board.
-
Step 4: Solder a wire onto the middle pin and the other end of the wire to your button.
-
Step 5: Attach your button.
Detailed Guide
You will need a Safety-TORX screwdriver to do so or a flat headed screwdriver.
There are 7 screws in total. 6 visible, another, hidden behind a sticker near the bottom under the battery pack.
Carefully take the front off the controller and set the buttons and other things down somewhere.
If you lose them you can't put your controller back together. , Look to the far right. there should be three little silver pins; one on top another in a line. , Be careful not to get the solder on the circuit board.
This could cause problems with the controller. , This only works with some guns and increases accuracy.
About the Author
Stephen Jordan
Creates helpful guides on creative arts to inspire and educate readers.
Rate This Guide
How helpful was this guide? Click to rate: