How to Make Ribbon Loops on Wire Stems
Lay the ribbon out flat on the workspace., Make the loops., Cut off the remainder of the ribbon., Place the wire over the centre of the loops (the part where your fingers can hold all the loops together at one end)., Done.
Step-by-Step Guide
-
Step 1: Lay the ribbon out flat on the workspace.
Cut the wire to the length desired before proceeding. -
Step 2: Make the loops.
Going from the top of the ribbon (choose an end) make loops by folding loosely backwards and forwards two to three times until you reach the bottom of the ribbon.
The amount of loops depend on how large you want the final product to be. , Use a diagonal cut to prevent further unravelling of the ribbon. , Twist around tightly to hold the loops firmly in place. , -
Step 3: Cut off the remainder of the ribbon.
-
Step 4: Place the wire over the centre of the loops (the part where your fingers can hold all the loops together at one end).
Detailed Guide
Cut the wire to the length desired before proceeding.
Going from the top of the ribbon (choose an end) make loops by folding loosely backwards and forwards two to three times until you reach the bottom of the ribbon.
The amount of loops depend on how large you want the final product to be. , Use a diagonal cut to prevent further unravelling of the ribbon. , Twist around tightly to hold the loops firmly in place. ,
About the Author
Alexis Young
Professional writer focused on creating easy-to-follow hobbies tutorials.
Rate This Guide
How helpful was this guide? Click to rate: