How to Install Electrical Conduits
Choose the right material for installing electrical conduit fittings: The most preferred material is known as EMT (Electrical Metallic Tubing)., Chalk out a wiring plan: Find out the location of the electrical boxes on your wall to trace the route...
Step-by-Step Guide
-
Step 1: Choose the right material for installing electrical conduit fittings: The most preferred material is known as EMT (Electrical Metallic Tubing).
EMT is very easy to install as you can effortlessly bend it and assemble it as per your needs.
Also, you can conveniently take it off in case your wiring goes wrong somewhere.
If you do not have it in your house, you can buy EMT from any of the electrical surplus stores for pretty cheap. -
Step 2: Chalk out a wiring plan: Find out the location of the electrical boxes on your wall to trace the route of the conduit.
Draw the path from the main power source to the electrical box. , Now cut the length that you just measured with a tool called hacksaw.
The cut ends are likely to have burrs which can be removed using a deburring tool or with pliers. , Owing to the easy flexibility of EMT, this should not be very difficult.
Conduit benders come in handy for doing this bending. ,, Fix together the ends along with the electrical wires with the same fish tape.
Give a finishing touch by pulling all the wire in the pipe in their right place. -
Step 3: Measure the amount of conduit that you would need: Make appropriate marks in pencil wherever you think the bends should be
-
Step 4: and measure the total length of the conduit that would be needed to finish the entire electrical conduit fittings.
-
Step 5: Make the necessary bends: It is now time to make bends that you had marked on the pipe in the previous step.
-
Step 6: Attach fittings to the wall: You can use screws and straps with either single or double holes
-
Step 7: available at electrical surplus shops
-
Step 8: to attach electrical conduit fittings to the wall.
-
Step 9: Tape the ends and put the wires in place: Use a widely available fish tape and run it through the entire route of the conduit fittings you just installed.
Detailed Guide
EMT is very easy to install as you can effortlessly bend it and assemble it as per your needs.
Also, you can conveniently take it off in case your wiring goes wrong somewhere.
If you do not have it in your house, you can buy EMT from any of the electrical surplus stores for pretty cheap.
Draw the path from the main power source to the electrical box. , Now cut the length that you just measured with a tool called hacksaw.
The cut ends are likely to have burrs which can be removed using a deburring tool or with pliers. , Owing to the easy flexibility of EMT, this should not be very difficult.
Conduit benders come in handy for doing this bending. ,, Fix together the ends along with the electrical wires with the same fish tape.
Give a finishing touch by pulling all the wire in the pipe in their right place.
About the Author
Jason Powell
Committed to making practical skills accessible and understandable for everyone.
Rate This Guide
How helpful was this guide? Click to rate: