How to Quickly Repair Bathroom Shower Tiles
Remove damaged tiles together with tile adhesive (cement under tiles)., Make sure any waterproof membrane is undamaged before proceeding., Get some ceramic tile adhesive, or thinset tile cement and apply it to the substrate with a notched trowel...
Step-by-Step Guide
-
Step 1: Remove damaged tiles together with tile adhesive (cement under tiles).
You may have to break the tile into small pieces and remove it.
The biggest problem with this is that you can easily break some of the adjoining tiles.
Using a grout saw or other tool, remove the grout from the tile joints surrounding the damaged tile(s).
Be careful not to cut through any membrane waterproofing underneath or behind the tiles.
Using a masonry bit, drill a hole through the middle of the tiles you need to remove.
For large tiles you may need to drill several holes so the tile can be broken up to remove it.
Again, be careful not to drill too deep, or the substrate and/or any waterproofing membrane may be damaged.
Use a chisel to break out the tile(s) in small pieces.
Remove the thinset mortar or tile adhesive behind the tile you have removed.
You will need a smooth, clean surface to install the replacement tile(s) on. -
Step 2: Make sure any waterproof membrane is undamaged before proceeding.
You may have to repair rubber or vinyl membranes to assure there isn't a leak underneath the tiles you are replacing, and the methods for doing so vary depending on the membrane used. , For small repairs, you may have to use a putty knife to apply this material. , Make sure the joints around the tile are uniform, and the surface of the newly installed tile(s) are flush with the surrounding tiles. , Use a sponge and plenty of water to clean excess grout off the tile's surface.
Once this material has dried and cured, it is difficult to remove. , -
Step 3: Get some ceramic tile adhesive
-
Step 4: or thinset tile cement and apply it to the substrate with a notched trowel.
-
Step 5: Replace the tile by pushing it into the adhesive or thinset firmly so it is bedded in the material.
-
Step 6: Wait for the tile adhesive to dry and then grout the joints surrounding any new tiles you have installed.
-
Step 7: Use a good
-
Step 8: waterproof bathroom sealant or caulk to repair any joints that do not lend themselves to grouting
-
Step 9: such as metal trim or fixture penetrations.
Detailed Guide
You may have to break the tile into small pieces and remove it.
The biggest problem with this is that you can easily break some of the adjoining tiles.
Using a grout saw or other tool, remove the grout from the tile joints surrounding the damaged tile(s).
Be careful not to cut through any membrane waterproofing underneath or behind the tiles.
Using a masonry bit, drill a hole through the middle of the tiles you need to remove.
For large tiles you may need to drill several holes so the tile can be broken up to remove it.
Again, be careful not to drill too deep, or the substrate and/or any waterproofing membrane may be damaged.
Use a chisel to break out the tile(s) in small pieces.
Remove the thinset mortar or tile adhesive behind the tile you have removed.
You will need a smooth, clean surface to install the replacement tile(s) on.
You may have to repair rubber or vinyl membranes to assure there isn't a leak underneath the tiles you are replacing, and the methods for doing so vary depending on the membrane used. , For small repairs, you may have to use a putty knife to apply this material. , Make sure the joints around the tile are uniform, and the surface of the newly installed tile(s) are flush with the surrounding tiles. , Use a sponge and plenty of water to clean excess grout off the tile's surface.
Once this material has dried and cured, it is difficult to remove. ,
About the Author
Michael Ford
Writer and educator with a focus on practical cooking knowledge.
Rate This Guide
How helpful was this guide? Click to rate: