How to Transplant a Jade Plant

Step-by-Step Guide

1. 1

   Step 1: Transplant the jade plant in early spring.

   This is the time when they are just entering a season of vigorous growth.They recover from the stress of being repotted more easily and quickly during this season.
2. 2

   Step 2: Use a heavy clay

   This will help to keep the plant upright.Jade plants tend to become top heavy and fall over easily. , This will allow excess water to drain from the pot.
   
   If the excess water cannot drain away, it will keep the potting soil too moist and restrict air movement which can cause root rot and kill the plant. , Larger containers will encourage excessive root growth or hold too much soil around the roots which will keep them wet for too long., This will allow the soil to drain more quickly.You can mix the perlite or sand into the potting mix at a ratio of two-thirds potting mix and one-third perlite or sand. , The top of the jade plant root mass should be about 1 inch below the top of the container after it is transplanted. , Do this by laying the pot on its side, grasping the base of the stem in your hand and sliding the roots out., Soak them in the disinfectant for five minutes, rinse them in tap water and dry them off with a clean towel.
   
   This will kill fungal spores and bacteria that may infect the jade plant. , Then, cut the roots off so they are even with the rest of the root mass.
   
   Trimming off these long roots will cause the plant to develop a healthier root system within the root mass. , Then, fill in the spaces around the roots with potting mix. , This will settle the soil around the roots and give the plant some moisture.
   
   If there is a saucer beneath the container to catch the water that drains from the hole, empty it after watering the plant.
   
   Water left in the saucer could leach back up into the potting mix and keep the roots too wet. , The jade plant will be stressed from being transplanted and should be cared for a little differently while it recovers. , The jade plant needs to be watered more often than usual because the root system has been compromised and cannot absorb water efficiently.Room-temperature water will not shock the roots like cold tap water.
   
   If the jade plant is not getting enough water, its succulent leaves will begin to shrivel and may develop brown spots., Too much water will cause the leaves to turn yellow. , The jade plant does not need fertilizer during this time and it could burn the roots. , As the leaves are not receiving moisture as efficiently as usual, they could be burned by too much sunlight.
3. 3

   Step 3: terra cotta or ceramic container.

4. 4

   Step 4: Make sure the container has at least one drain hole in the bottom.

5. 5

   Step 5: Find a container that is only 1 to 2 inches deeper and wider than the old container.

6. 6

   Step 6: Use a peat-based potting mix with extra coarse builder’s sand or perlite added in.

7. 7

   Step 7: Put the new potting mix into the container at a depth of 1 to 2 inches.

8. 8

   Step 8: Remove the jade plant from its old container.

9. 9

   Step 9: Disinfect a pair of sharp scissors with a household disinfectant like Lysol.

10. 10

    Step 10: Trim off any roots that are much longer than the root mass.

11. 11

    Step 11: Put the jade plant in the new container.

12. 12

    Step 12: Water the jade plant with room-temperature water until it drains from the bottom.

13. 13

    Step 13: Take special care of the jade plant for four weeks after transplanting it.

14. 14

    Step 14: Water the plant with room-temperature water when the top of the potting mix begins to dry.

15. 15

    Step 15: Do not overwater the plant.

16. 16

    Step 16: Avoid giving the plant any fertilizer while the root system is recovering.

17. 17

    Step 17: Keep the plant out of direct sunlight.

Detailed Guide

About the Author