How to Use an Ultrasonic Cleaner to Clean Your Jewelry

Step-by-Step Guide

1. 1

   Step 1: Fill the tank of your cleaner with water adding a tablespoon of ammonia.

   Don't use too much because it can be harmful.
2. 2

   Step 2: Add some dishwashing liquid

   ,, Remember not to put in too many pieces at once or it may scratch your jewelry. , To work best, it needs to heat the solution hot.
   
   There are many ultrasonic cleaners that have a built-in heater to ensure that the solution is heated up.
   
   They differ in price.
   
   Just heat the water up before you put it in the tank.
   
   Do not bring the water to a boil.
   
   Mix in the ammonia and the dishwashing liquid Set the temperatures you need. , Let it run for as long as needed until your jewelry is clean.
   
   Depending on how dirty the items are, this time usually varies from 1 to 20 minutes , Leave your jewelry inside for another 5-10 minutes so that the dirt particles can fall to the bottom of the tank. , Make sure that any residual dirt is removed, especially from the mountings of your rings. , Wash off any remaining detergent, and dry them with a soft cloth.
3. 3

   Step 3: and you are done.

4. 4

   Step 4: Turn on the cleaner and let it run without any items for 5-10 minutes so that the solution gets mixed well.

5. 5

   Step 5: Put your item(s) into the tank.

6. 6

   Step 6: Heat the solution to hot and set temperatures you need.

7. 7

   Step 7: Turn the device on.

8. 8

   Step 8: When the cleaning is done

9. 9

   Step 9: switch the cleaner off.

10. 10

    Step 10: Take your jewelry out and clean it briefly with a soft brush.

11. 11

    Step 11: Rinse the items.

Detailed Guide

About the Author