How to Access the Mechbox in a Classic Army SAR Airsoft Gun

Step-by-Step Guide

1. 1

   Step 1: Take precautions: Anything you do to your gun is at your own risk

   Every time you take out a part, put it in a place where you’re sure to find it.
   
   Remember where you got the part from so you know where to put it back.
   
   It might be a good idea to take a picture to remember it the first couple of times.
   
   Take out the magazine, and fire a shot or two in a safe direction.
   
   Put the safety on.
   
   Remove the battery to prevent mishaps.
2. 2

   Step 2: and you lose the shop warranty.

   Be careful not to rip apart the wires that go from the stock to the receiver.
   
   They need to be unplugged properly, Press out the pin next to the magwell., It looks like a large pistol., There are two small screws at the bottom of the grip.
   
   While pressing down on the metal plate, take out the screws.
   
   Be careful with the screwdriver
   - see Warnings below., You can use a small screwdriver to lift them up.,,,
3. 3

   Step 3: Remove the two pins that keep the stock together with the rest of the gun

4. 4

   Step 4: and carefully pull the stock from the rest of the gun.

5. 5

   Step 5: Put the gun on the table facing right.

6. 6

   Step 6: Gently pull off the lower part of the gun..

7. 7

   Step 7: Turn the "pistol" upside down.

8. 8

   Step 8: Note the positions of the red and a black wires connected to the motor

9. 9

   Step 9: as they need to be put together the same way later.

10. 10

    Step 10: Lift out the motor.

11. 11

    Step 11: Take out the two small screws inside the grip.

12. 12

    Step 12: Gently take the wires out through the holes in the pistol grip

13. 13

    Step 13: and remove the metal housing from the mechbox

14. 14

    Step 14: and the mechbox should now be out.

Detailed Guide

About the Author