How to Card Wool

Shake off any superficial dirt or vegetation., Fill a basin with warm water., Pour in several squirts of dishwashing detergent., Submerge your wool., Drain your sink., Rinse the wool of all soap., Place the wet wool on top of a thick towel., Lay the...

17 Steps 5 min read Advanced

Step-by-Step Guide

  1. Step 1: Shake off any superficial dirt or vegetation.

    You will want to card only clean wool, as any dirt particles could hamper your ability to use the wool carders.

    Freshly shorn sheep’s wool will also have dirt deep in the fibers, so you will need to be sure you wash it thoroughly.
  2. Step 2: Fill a basin with warm water.

    Grab a bucket or clean out a sink to use as a washing basin.

    The basin should be large enough to comfortably contain the amount of wool you would like to clean.

    The temperature should be at approximately 180 degrees Fahrenheit (82 Celsius).

    Water that is too hot will strip the wool of natural oils. , To protect the woolen fibers, avoid soap or detergents that contain bleach or similar whitening additives.

    Stir the detergent into the water until the water is soapy.For best results, use a soap or detergent with a pH between 7 and
    9.

    Most mild dish soaps are neutral (a pH of 7) and should be safe to use for cleaning wool.Mild dish soaps can be purchased at any drug or grocery store near you. , Let the wool soak for about ten minutes in the basin of warm water.

    This should loosen the dirt particles, making it easier for the dirt to separate from the wool or for you to remove it with some light scrubbing.

    Rub the wool with your hands to wash it thoroughly.Repeat the process as necessary.

    You may need to soak the wool 2-3 times before it is completely clean. , Remove the wool and pull the stopper to allow your sink to drain or dump the water out of your bucket.

    Rinse out any remaining dirt in your sink or bucket. , You will know it has been thoroughly rinsed when you notice that the bubbles from the detergent are gone.

    You may need to rinse the wool three or more times., This will absorb the excess water in the wool, allowing it to dry a bit faster.

    Wrap it in the towel and gently squeeze to pull out as much excess moisture as possible., You can do this by clearing a space on a desk or countertop and laying the wool on another clean and dry towel.

    You could also lay it flat on a drying rack.

    Allow the wool to dry overnight.

    Do not attempt to card the wool until it is completely dry. , Carders are wooden paddles covered in pin board and they often closely resemble cat or dog hair brushes.

    Be sure to avoid purchasing carders made for cotton and purchase ones specifically made for wool.Wool carders come in small and large sizes.

    Larger sizes can be harder to manage if you have little upper body strength.

    Some wool carders have teeth that are very close together.

    They are harder to drag apart but align the wool into finer wool.

    Hand carders have different types of teeth as well, which are used for different purposes.

    Carders with coarse teeth are used for carding coarse fibers, such as wool and mohair.

    Hand carders with fine teeth are generally used for carding softer fibers like cotton and angora. , The wool should be touching the side of the carder with the pin board.

    You will want to cover it the surface of the carder until almost all the teeth are covered but not so there is an excess of wool hanging off the side of the carder.

    Do not cover other carder with wool. , Place the full carder on the on your left knee with the wool facing up.

    Hold the handle of this carder with your left hand.

    Switch hands and knee if your left hand is your dominant hand. , The carder should be oriented so that the pin paper is facing down and toward the wool on the other carder. , Begin at the top end of the full carder (opposite the handle).

    Work your way gently from the top to the bottom in full strokes moving in one direction.

    There is no need to press very hard.

    The pin paper should grab a few fibers at a time, straightening it onto the second carder., If you see any knots, continue brushing until they are removed and transferred onto the surface of the other carder.

    This could take up to five minutes to complete, depending on how fast or slow you prefer to go. , Transfer the now-full carder to the left knee.

    Take the empty carder into your right hand.

    Gently brush the empty carder over top the full one, as you did previously. , You will continue to switch your carders until no dirt appears and the wool is very uniform.

    Look closely at the brushed fibers.

    If they are falling in parallel lines, then it is ready. , Start at the top of the carder and slowly move to the handle, lifting the wool the whole way.

    You can use the other carder to help lift the top of the fibers up and back.

    As you lift, you can gently and loosely roll the wool until it resembles a burrito.

    Once the fiber is rolled, it is referred to as a rolag.
  3. Step 3: Pour in several squirts of dishwashing detergent.

  4. Step 4: Submerge your wool.

  5. Step 5: Drain your sink.

  6. Step 6: Rinse the wool of all soap.

  7. Step 7: Place the wet wool on top of a thick towel.

  8. Step 8: Lay the wool flat to dry.

  9. Step 9: Purchase hand carders from a spinning or hobby store.

  10. Step 10: Cover one carder with a thin layer of wool.

  11. Step 11: Sit down with an empty lap.

  12. Step 12: Hold the empty carder by the handle in your right (or dominant) hand.

  13. Step 13: Brush the empty carder over the top of the other carder.

  14. Step 14: Repeat the process until all of the wool is transferred onto the right carder.

  15. Step 15: Repeat the hand carding process to further refine the wool.

  16. Step 16: Continue to switch carders.

  17. Step 17: Lift the refined carded wool from the carder.

Detailed Guide

You will want to card only clean wool, as any dirt particles could hamper your ability to use the wool carders.

Freshly shorn sheep’s wool will also have dirt deep in the fibers, so you will need to be sure you wash it thoroughly.

Grab a bucket or clean out a sink to use as a washing basin.

The basin should be large enough to comfortably contain the amount of wool you would like to clean.

The temperature should be at approximately 180 degrees Fahrenheit (82 Celsius).

Water that is too hot will strip the wool of natural oils. , To protect the woolen fibers, avoid soap or detergents that contain bleach or similar whitening additives.

Stir the detergent into the water until the water is soapy.For best results, use a soap or detergent with a pH between 7 and
9.

Most mild dish soaps are neutral (a pH of 7) and should be safe to use for cleaning wool.Mild dish soaps can be purchased at any drug or grocery store near you. , Let the wool soak for about ten minutes in the basin of warm water.

This should loosen the dirt particles, making it easier for the dirt to separate from the wool or for you to remove it with some light scrubbing.

Rub the wool with your hands to wash it thoroughly.Repeat the process as necessary.

You may need to soak the wool 2-3 times before it is completely clean. , Remove the wool and pull the stopper to allow your sink to drain or dump the water out of your bucket.

Rinse out any remaining dirt in your sink or bucket. , You will know it has been thoroughly rinsed when you notice that the bubbles from the detergent are gone.

You may need to rinse the wool three or more times., This will absorb the excess water in the wool, allowing it to dry a bit faster.

Wrap it in the towel and gently squeeze to pull out as much excess moisture as possible., You can do this by clearing a space on a desk or countertop and laying the wool on another clean and dry towel.

You could also lay it flat on a drying rack.

Allow the wool to dry overnight.

Do not attempt to card the wool until it is completely dry. , Carders are wooden paddles covered in pin board and they often closely resemble cat or dog hair brushes.

Be sure to avoid purchasing carders made for cotton and purchase ones specifically made for wool.Wool carders come in small and large sizes.

Larger sizes can be harder to manage if you have little upper body strength.

Some wool carders have teeth that are very close together.

They are harder to drag apart but align the wool into finer wool.

Hand carders have different types of teeth as well, which are used for different purposes.

Carders with coarse teeth are used for carding coarse fibers, such as wool and mohair.

Hand carders with fine teeth are generally used for carding softer fibers like cotton and angora. , The wool should be touching the side of the carder with the pin board.

You will want to cover it the surface of the carder until almost all the teeth are covered but not so there is an excess of wool hanging off the side of the carder.

Do not cover other carder with wool. , Place the full carder on the on your left knee with the wool facing up.

Hold the handle of this carder with your left hand.

Switch hands and knee if your left hand is your dominant hand. , The carder should be oriented so that the pin paper is facing down and toward the wool on the other carder. , Begin at the top end of the full carder (opposite the handle).

Work your way gently from the top to the bottom in full strokes moving in one direction.

There is no need to press very hard.

The pin paper should grab a few fibers at a time, straightening it onto the second carder., If you see any knots, continue brushing until they are removed and transferred onto the surface of the other carder.

This could take up to five minutes to complete, depending on how fast or slow you prefer to go. , Transfer the now-full carder to the left knee.

Take the empty carder into your right hand.

Gently brush the empty carder over top the full one, as you did previously. , You will continue to switch your carders until no dirt appears and the wool is very uniform.

Look closely at the brushed fibers.

If they are falling in parallel lines, then it is ready. , Start at the top of the carder and slowly move to the handle, lifting the wool the whole way.

You can use the other carder to help lift the top of the fibers up and back.

As you lift, you can gently and loosely roll the wool until it resembles a burrito.

Once the fiber is rolled, it is referred to as a rolag.

About the Author

S

Steven Adams

Specializes in breaking down complex home improvement topics into simple steps.

48 articles
View all articles

Rate This Guide

--
Loading...
5
0
4
0
3
0
2
0
1
0

How helpful was this guide? Click to rate: