How to Easily Modify a Nerf Longshot

Step-by-Step Guide

1. 1

   Step 1: Remove all darts and clip.

   Make sure that there is nothing loaded in the gun.
2. 2

   Step 2: Pull the rod back and then forward.

   This is just the same as reloading. , You will see a very small hole on the end of the black piston.
   
   When the gun fires, this hole lets an amount of air escape, disabling the gun's full potential power. (This is not the air restrictor, but it does reduce the power of the gun. ) , This will block the air from escaping, causing more air to push the dart out of the barrel. , The dart should go much farther now.
3. 3

   Step 3: Flip the gun upside down and look into the clip slot with a flashlight.

4. 4

   Step 4: Place a piece of very strong

5. 5

   Step 5: thin tape on the hole.

6. 6

   Step 6: Load a clip and test fire.

Detailed Guide

About the Author