How to Make an Ulama Hoop Model

Step-by-Step Guide

1. 1

   Step 1: Take a plain

   Take a pencil and outline two parallel lines running vertically from the bottom center.
   
   Stop at the middle.
2. 2

   Step 2: rectangular bar of soap.

   Make sure it is perfectly round. ,, Slowly, carefully, begin spinning the knife to drill through the circle to make a hole. , Put them aside, and get out some paint.
   
   One a shade of brown, the other either red or yellow (preferably red). , Let it dry once you have covered all of it. , Dip it in the other paint and draw on Aztec symbols on both sides. , Fill it with hot water.
   
   Gather the shavings and place them in. , Carefully drain the water, and pick up the wet shavings. , Make a ball out of them.
   
   Try fitting it through the hoop, then let it dry once it fits. ,
3. 3

   Step 3: Outline a circle where the lines stopped.

4. 4

   Step 4: Take a butter knife

5. 5

   Step 5: and start shaving away at the soap outside the outlined area.

6. 6

   Step 6: Place the tip of the butter knife at the center of the circle.

7. 7

   Step 7: Collect the shavings.

8. 8

   Step 8: Paint the soap brown.

9. 9

   Step 9: Take the metal end of a paperclip.

10. 10

    Step 10: Get out a glass bowl.

11. 11

    Step 11: Wait for about 5 minutes.

12. 12

    Step 12: Mold them together.

13. 13

    Step 13: Paint the ball brown

14. 14

    Step 14: and let it dry.

Detailed Guide

About the Author