How to Make Leaf Stepping Stones
Cut plastic sheeting that is approximately 15 centimeter (5.9 in)., Place leaf on top of plastic sheeting., Mix concrete according to package directions and then apply directly to leaf., Cut chicken wire to leaf size and place over to the top of the...
Step-by-Step Guide
-
Step 1: Cut plastic sheeting that is approximately 15 centimeter (5.9 in).
larger than your leaf.
Place sheeting on the ground.
Make sure area is clear of debris and additional leaves.
Also, this project works best in an area that is free of any moisture. -
Step 2: Place leaf on top of plastic sheeting.
Make sure the leaf is centered and the veins are face up. , Working quickly, use gloved hands to integrate concrete mixture together.
Spread mixture over the leaf until you achieve a thickness of approximately
2.5 to 4 centimeter (1.0 to
1.6 in).
Smooth hand over concrete to remove air bubbles and create a flat surface. , Cut wire to within 5 centimeter (2.0 in). of the edge, overlapping pieces if necessary.
Add more concrete over the chicken wire, spread again to a
2.5 to 4 centimeter (1.0 to
1.6 in). thickness.
Smooth your hand over the top to remove bubbles. , The plastic will remain in place as the design cures and dries, which could take up to 48 hours.
Add a second piece of plastic over the top of the design to ensure it cures properly and does not simply dry out. , If you worked in a humid environment, the leaf may have already decomposed and broken down.
Use a hose with jet spray nozzle to remove remaining leaf pieces. , You can place the stones in the desired area, but avoid walking on them until the curing process has finished. -
Step 3: Mix concrete according to package directions and then apply directly to leaf.
-
Step 4: Cut chicken wire to leaf size and place over to the top of the concrete covered leaf.
-
Step 5: Wrap edges and leaf in the remaining portion of the plastic
-
Step 6: taking care to adhere plastic to design with fingers.
-
Step 7: Peel away small pieces of leaf once design has cured.
-
Step 8: Spray stones over the next several days as the curing process takes nearly a week to complete.
Detailed Guide
larger than your leaf.
Place sheeting on the ground.
Make sure area is clear of debris and additional leaves.
Also, this project works best in an area that is free of any moisture.
Make sure the leaf is centered and the veins are face up. , Working quickly, use gloved hands to integrate concrete mixture together.
Spread mixture over the leaf until you achieve a thickness of approximately
2.5 to 4 centimeter (1.0 to
1.6 in).
Smooth hand over concrete to remove air bubbles and create a flat surface. , Cut wire to within 5 centimeter (2.0 in). of the edge, overlapping pieces if necessary.
Add more concrete over the chicken wire, spread again to a
2.5 to 4 centimeter (1.0 to
1.6 in). thickness.
Smooth your hand over the top to remove bubbles. , The plastic will remain in place as the design cures and dries, which could take up to 48 hours.
Add a second piece of plastic over the top of the design to ensure it cures properly and does not simply dry out. , If you worked in a humid environment, the leaf may have already decomposed and broken down.
Use a hose with jet spray nozzle to remove remaining leaf pieces. , You can place the stones in the desired area, but avoid walking on them until the curing process has finished.
About the Author
Carolyn Lee
A passionate writer with expertise in lifestyle topics. Loves sharing practical knowledge.
Rate This Guide
How helpful was this guide? Click to rate: