How to Reassemble Your Fat PS

Step-by-Step Guide

1. 1

   Step 1: Use three small sliver screws to screw the fan back onto the bottom of the heat sink board.

   place it onto the heat sink board as the parts fall right into place when you put it on. , Plug it into the small white part on the bottom part of the green board where the CPU and GPU are located. , The top of the gray cover plate has two sliver tongs sitting up so have the top of the gray cover plate face up. , Put it into the bottom part of the PS3 so that that the fan is on the bottom and the hard drive slot is on the left going in., The board will have arrows pointing at holes where you should put the screws in.,, Place it on the right side of the PS3 while grabbing the ribbon on the bottom of it.
   
   Put that on the green board by gently pulling the black chip up and make sure that the legs of the CD drive are aligned to the gray coverboard. ,, Put it on top of the gold sticks on the board and plug the cord from the power supply into the other white part on the board. , There should be three in the front and two in the back., You will have to use three small sliver screws to put it back on and one sliver screw for the string connected to the Bluetooth. , To do this, plug the cord into the back of the power supply while sitting the back part onto the system., Put it on the top; there will be arrows pointing where you should screw it down using the tall sliver screws.
   
   There will be six tall sliver screws and one slightly shorter screw.
   
   Put that screw into the arrow that has an S above it. , Slide that back onto the top., Put it back into the slot and use three small screws to put it back on.
   
   Then you're all set!
2. 2

   Step 2: Grab the CPU and GPU.

3. 3

   Step 3: Get the cable from the fan.

4. 4

   Step 4: Grab the gray cover plate.

5. 5

   Step 5: Grab the bottom of the PS3

6. 6

   Step 6: and the entire part of the green board and gray coverboard.

7. 7

   Step 7: Screw down the gray cover board using the small sliver screws.

8. 8

   Step 8: Screw both of the sliver tongues onto the top of the gray cover board using the four black screws.

9. 9

   Step 9: Grab the CD drive.

10. 10

    Step 10: Plug the cord from the CD drive into the front white part on the board.

11. 11

    Step 11: Grab the power supply.

12. 12

    Step 12: Screw down the power supply with 5 small sliver screws.

13. 13

    Step 13: Put the bluetooth back on its stand.

14. 14

    Step 14: Put the back part of the PS3 back on.

15. 15

    Step 15: Grab the top part of the PS3.

16. 16

    Step 16: Grab the PS3 cover.

17. 17

    Step 17: Put the hard drive back in.

Detailed Guide

About the Author