How to Save Energy with Your Hot Tub

Program your filter/heat cycles to run at night if you have a "night-rate" meter., Leave all air controls/valves OFF, as you don't want to pull in outside air to push through your jets when the tub is not being used. , Consult your owner's manual to...

21 Steps 1 min read Advanced

Step-by-Step Guide

  1. Step 1: Program your filter/heat cycles to run at night if you have a "night-rate" meter.

    It may cost now, but will save you energy and ease-of-use in the long run. ,,, We recommend foil-faced bubble-wrap, available at most home improvement stores.

    It's waterproof, cuts w/ scissors, staples/stuffs in and is R3 per 1/4" (the 'double-bubble' is best). ,, Is there any voids where heat is sneaking out (and mice sneaking in)? ,,
  2. Step 2: Leave all air controls/valves OFF

  3. Step 3: as you don't want to pull in outside air to push through your jets when the tub is not being used.

  4. Step 4: Consult your owner's manual to see if your controls have a "economy" or "standby" mode

  5. Step 5: leaving your tub 10-15 degrees cooler than your set temp.

  6. Step 6: Use a "thermal blanket" or "solar cover" to keep evaporation down under your spa cover.

  7. Step 7: Break down and buy that new cover!

  8. Step 8: Portable spa owners will benefit from a layer of foam board insulation under the tub

  9. Step 9: as they are typically not well insulated on the floor.

  10. Step 10: Obstruct prevailing winds with a privacy panel or fence...this sometimes can lead to BIG energy savings.

  11. Step 11: Take a peek inside your spa cabinet...can you add some insulation?

  12. Step 12: Keep tub out from under drip edges

  13. Step 13: as water and ice falling on cover/cabinet will drop temps more than normal.

  14. Step 14: Closely inspect bottom and top perimeter of your cabinet.

  15. Step 15: This is a tough one

  16. Step 16: but positioning your tub on a South-facing exposure

  17. Step 17: or in a sun-exposed corner does wonders for melting snow/ice

  18. Step 18: and keeping temps up on the spa cover vinyl.

  19. Step 19: Lastly

  20. Step 20: be sure to use your spa on the coldest nights when you have a chill...that's why you spent all that money

  21. Step 21: right?

Detailed Guide

It may cost now, but will save you energy and ease-of-use in the long run. ,,, We recommend foil-faced bubble-wrap, available at most home improvement stores.

It's waterproof, cuts w/ scissors, staples/stuffs in and is R3 per 1/4" (the 'double-bubble' is best). ,, Is there any voids where heat is sneaking out (and mice sneaking in)? ,,

About the Author

B

Brenda Gonzales

Brings years of experience writing about DIY projects and related subjects.

151 articles
View all articles

Rate This Guide

--
Loading...
5
0
4
0
3
0
2
0
1
0

How helpful was this guide? Click to rate: