How to Wire and Apply the LED Remote Control

Step-by-Step Guide

1. 1

   Step 1: Consolidate the base onto the required mounting point.

   Four inner exposed holes are the fixing holes for the wall surface mounting and electric drill is strongly recommended. , The particular wiring course should be strictly complied with ,,, There are four zones for brightness adjustment, including power setting belt, Rough adjustment belt, Hotkey belt and self-setting mode belt.,, The rough adjustment buttons is combined of two buttons, up brightness button is with upward arrow mark and the downward arrow is for the brightness’s down., Select one you desire, and feel the illumination in various lighting level , Just hold on until the brightness is exactly what you want, press one of the buttons for 3 seconds, and then will a flash light be on for once and here the setting lighting is remembered, and if it succeed , you can press the setting button for your favor brightness.
   
   Otherwise, pressing time is less than regulated 3s, the display lighting is just the previous light. , Delay off
2. 2

   Step 2: Pull the wiring lines through the card slot and connect to the wiring points.

3. 3

   Step 3: Screw the body plate on the base

4. 4

   Step 4: ensure that the black receiver is exactly located at the outright top of the lamp body

5. 5

   Step 5: Press down the top plate on the body plate

6. 6

   Step 6: attention that the frosted plastic lighting slice of top plate should just on the embedded receiver lights.

7. 7

   Step 7: Recognize the main function areas.

8. 8

   Step 8: Turning on the power

9. 9

   Step 9: just by a simple click of the red “ON/OFF”.

10. 10

    Step 10: ON/OFF Add or subtract the brightness.

11. 11

    Step 11: Apply the Hotkey switch

12. 12

    Step 12: all the hotkeys are programmed with the specific percentage of the total brightness (25%

13. 13

    Step 13: 100%).

14. 14

    Step 14: Access to the self-setting mode

15. 15

    Step 15: most part of dimmer would be set the memory mechanism for personal favor.

16. 16

    Step 16: Press the Delay off

17. 17

    Step 17: automatically will the light be off within 30s.

Detailed Guide

About the Author