How to Make a Fat Origami Rabbit

Get a piece of origami paper or cut a piece of printer or construction paper into a 5 inch by 5 inch (13cm) square., Fold the paper diagonally, and crease the paper well., Fold, crease, and unfold the paper diagonally again, but this time the other...

29 Steps 1 min read Advanced

Step-by-Step Guide

Step 1: Get a piece of origami paper or cut a piece of printer or construction paper into a 5 inch by 5 inch (13cm) square.

Lay your paper down on a flat surface.

If you have two-colored paper, the side facing down will be the outside of the rabbit.

Step 2: Fold the paper diagonally

Then, unfold it. ,,, Make the sides touch, and push down on the top. ,,, Take the triangles and push a bit on the side so there's a little "pocket".

Then, take the top of the diamond and put it in the "pocket".

Do this to both sides. ,,,,,,,, The rabbit should be symmetrical. ,,, There should be a hole that looks in at the inside of the rabbit.

Put your mouth on it and blow.

This should inflate the rabbit. ,,

Step 3: and crease the paper well.

Step 4: crease

Step 5: and unfold the paper diagonally again

Step 6: but this time the other way.

Step 7: crease

Step 8: and unfold the paper horizontally

Step 9: Push the paper down in the middle

Step 10: and pull the sides up a little so they're popping out a little.

Step 11: Fold the edges of the first layer up to make a diamond.

Step 12: Take the sides of the diamond and fold them in so that the points are touching the center of the diamond.

Step 13: This is a bit tricky.

Step 14: Flip over the paper.

Step 15: Fold the corners up to make a diamond.

Step 16: Flip the right flap of the diamond over so that it's laying on the left side of the diamond.

Step 17: Fold the point of the right side until it reaches the crease.

Step 18: Flip the right side back over to the right.

Step 19: Take the left flap and flip it to the right side.

Step 20: Take the point of the left flap and fold it until it reaches the center crease.

Step 21: Flip the left flap of the rabbit back over so you are on the same side you were on earlier.

Step 22: Take the first layer and fold both sides until they touch the crease.

Step 23: Push open the first layers and push down the tops to make a triangle.

Step 24: Look at the front of the rabbit.

Step 25: Draw some eyes

Step 26: whiskers

Step 27: a nose

Step 28: and a smile for your rabbit's face.

Step 29: Finished.

Detailed Guide