How to Set Up a Portable Field Light Tower

Step-by-Step Guide

1. 1

   Step 1: Know that manufacturing companies understand!

   Light tower manufacturing and distribution companies completely know the importance of setting up and getting the portable field light tower in working order as quickly as possible.
   
   They also understand that not all companies will have the resources to set up a light tower.
   
   For this reason, most light tower companies provide a complete manual that not only provides all the parts and specifications, but also a step-by-step setup process. ,, Set the light tower up at a place with firm and flat earthen ground for better installation and usage When raising the mast, make sure it is higher than the general lights that may already be present on the ground.
   
   Bring the light tower to the location and make sure it is level Block the wheels of the trailer to keep it from moving during installation. , The twisting will snap the spring loaded pins into place.,,,,,,, Check mast cables, electrical cords, and cable pulleys for any damage.,, Secure the mast lock with the safety pin.,,
2. 2

   Step 2: When you receive your portable field light tower

3. 3

   Step 3: you will find the following components: Wheeled trailer with a tongue jack and locking pins An engine and a generator set within the trailer for power Light mast with lock bar and winches Junction box connecting flood lights and mast Flood lamps

4. 4

   Step 4: which are already attached to the mast 4 jack handles on trailer Safety and locking pins and outriggers already present within the trailer and the mast

5. 5

   Step 5: Before you begin the assembly of the light tower

6. 6

   Step 6: it is better to keep the following points in mind: Choose a location that is free from overhead wires so that there won’t be any tangling with the mast.

7. 7

   Step 7: Pull the tongue jack locking pin in an upwards motion and then twist to a 90 degree angle.

8. 8

   Step 8: Turning the jack handle in a clockwise direction

9. 9

   Step 9: raise the trailer off from the towing vehicle.

10. 10

    Step 10: On the trailer outriggers

11. 11

    Step 11: snap the spring loaded pins into place by pulling on the locking pins and rotating them at a 90 degree angle Repeat the previous step for the locking pins on the rear jack handle.

12. 12

    Step 12: To level the trailer

13. 13

    Step 13: turn the jack handle in a clockwise direction.

14. 14

    Step 14: Repeat the last step with the other 3 jack handles to root the trailer level on the ground

15. 15

    Step 15: Adjust the lamps to your requirement by loosening the wing bolts on the lamp fixture.

16. 16

    Step 16: Firmly connect the lamps to the junction box by tightening all hardware

17. 17

    Step 17: Remove the locking pin from the mast cradle.

18. 18

    Step 18: Remove the safety pin out from the lock bar of the mast.

19. 19

    Step 19: Use the lower mast winch handle to raise the mast to a vertical position.

20. 20

    Step 20: Use the upper mast winch to raise the tower to the desired height.

21. 21

    Step 21: Make sure that all cables and wires are moving smoothly.

Detailed Guide

About the Author