How to Program FC 7448 Alarm Panel

Step-by-Step Guide

1. 1

   Step 1: Enter Programming mode by pressing 9876#0

   Press “*” for 4 seconds until the “di” sound , The same goes for disarming.image ,, with 3 digits) , and password: press 1234#0, press “0”, then user No.(001-200), enter authority level(0-6) with “#”, then enter 4 digits password with “#”, password with “#” again. ,(001-200), enter user authority (0-6) with “#”, press 0# ,, After enter programming, LCD display Prog Mode
   4.05 Adr= , Fill in “Adr=” with 4 digits program address.
   
   Then input 21#, then the two digits will be displayed alternately.
   
   Press “#”, it will display “1”, press #* Again, it will display “2”.(It is default and can be changed by programming), then skip to next program address.
   
   If you need to program some address, just press”*” twice and it will return to Prog Mode
   4.05 Adr= Note:
   FC-7448 is shipped from the factory as a working, pre-programmed control.
   
   Many of the programming address may already be set to the values you need.
   
   The default values are shown in Reverse Print.
   
   You don’t need to pre-program this address. , "Zone function" means the zone is delay zone, instant zone, 24 hours zone etc.
   
   It is already programmed into the panel but you can change the default and add new zone function according to user’s manual.
   
   Zone programming (address is 0031—0278). "Zon programming" means the first zone, 0032 is the second one and so on.
   
   If you want to set the eighth zone as 24 hours zone, then you need to change the value of this address to “07” and press # to confirm.image
2. 2

   Step 2: (password +#0) then power LED and arm/disarm LED flash simultaneously

3. 3

   Step 3: LCD display Prg:Mode4.05 Adr=;

4. 4

   Step 4: Exit the programming mode.

5. 5

   Step 5: To arm the system

6. 6

   Step 6: press 1234(password) and “arm/disarm” button.

7. 7

   Step 7: To force arm: Press 1234(password) and “arm” + “bypass” buttons

8. 8

   Step 8: To Bypass: Press 1234(password) and “bypass”+xxx(zone No.

9. 9

   Step 9: To Add users Type your No.

10. 10

    Step 10: To Delete your user ID: Press 1234#0

11. 11

    Step 11: press “0”

12. 12

    Step 12: then user No.

13. 13

    Step 13: Enter programming address: -0030 is zone function program address -0278 is zone program address -0538 is zone features program address.image

14. 14

    Step 14: Fill in data: The program address is 4 digits and value of address is 2 digits.

15. 15

    Step 15: Enter program zone function (address is 0001—0030).

Detailed Guide

About the Author