How to Extend the Floor in SketchyPhysics
Create the floor., Double click on the floor. , Click on the Push/pull tool and start pulling it out., Do this for two sides., Alternatively, split the difference.
Step-by-Step Guide
-
Step 1: Create the floor.
To do any SketchyPhysics project, you need to have the floor.
If you'd like, measure the floor.
The floor that you are 'issued' is 83'4" X 83'4".
Figure out the difference between what you want and what you have.
If you have a 100 X 100, the difference is 16'8" -
Step 2: Double click on the floor.
, Type in the following and then hit enter. 16'8"
This will make it 100 feet (30.5 m) square. , If you want it to remain square with the axis indicators, you need to pull out each side by 8'4".
This will keep it centered on the axis on your screen. -
Step 3: Click on the Push/pull tool and start pulling it out.
-
Step 4: Do this for two sides.
-
Step 5: Alternatively
-
Step 6: split the difference.
Detailed Guide
To do any SketchyPhysics project, you need to have the floor.
If you'd like, measure the floor.
The floor that you are 'issued' is 83'4" X 83'4".
Figure out the difference between what you want and what you have.
If you have a 100 X 100, the difference is 16'8"
, Type in the following and then hit enter. 16'8"
This will make it 100 feet (30.5 m) square. , If you want it to remain square with the axis indicators, you need to pull out each side by 8'4".
This will keep it centered on the axis on your screen.
About the Author
Kyle Morales
Committed to making cooking accessible and understandable for everyone.
Rate This Guide
How helpful was this guide? Click to rate: