How to Give Your Build a Bear a Bath

Step-by-Step Guide

1. 1

   Step 1: Take all the clothing and accessories off the bear.

   These things need to be washed separately, and you need to get to clean all of the bear anyway.
2. 2

   Step 2: Fill a sink

   Make sure it's not too hot for the bear's fabric – if you make the water too hot it may shrink or harm the bear's fur. , Make sure the soap is a mild soap such as dish soap. ,, Gently scrub the bear's fur until the stains or heavy dirt come loose. , Make sure the soap goes with it. , Make sure there is no soap left. , Twist and squeeze as hard as you can.
   
   This is a very important step. ,, Only use low heat.
   
   Don't forget the dryer sheet if you use them. , Some build a bear has no fur, so just carefully put the clothes back.
   
   Your build a bear is now huggable and clean again.
3. 3

   Step 3: large bowl

4. 4

   Step 4: or basin up with lukewarm water.

5. 5

   Step 5: Put a little soap in the sink.

6. 6

   Step 6: Take a face cloth and lightly dip it in the soapy water

7. 7

   Step 7: rub this over your build-a-bear scrubbing till clean.

8. 8

   Step 8: Scrub the bear in stained areas using a soft toothbrush.

9. 9

   Step 9: Drain the water out.

10. 10

    Step 10: Rinse the bear with the face cloth.

11. 11

    Step 11: Try to get as much water out of your bear as possible.

12. 12

    Step 12: Rub your bear dry with a towel.

13. 13

    Step 13: Put your bear in the dryer.

14. 14

    Step 14: If the build a bear has a furry hair

15. 15

    Step 15: brush it until it is successfully dry.

Detailed Guide

About the Author