How to Make a Duct Tape iPod Pouch (Nano Second Generation)

Step-by-Step Guide

1. 1

   Step 1: Measure the width

   Lay the iPod on a piece of paper and measure it's dimensions and mark the measurements.
   
   Mark the depth of the bottom of the ipod Mark the length of the iPod Mark the depth of the top of the iPod Wrap the paper around the iPod and mark the width
2. 2

   Step 2: height and depth of your iPod.

   , Fold the top and bottom to measure the flaps.
   
   Wrap it like you are gift wrapping the iPod. , Then cut both of them out carefully with scissors or razor knife.
   
   Now you have your template. , Cut several pieces of duct tape and lay them onto the template starting from the bottom.
   
   Cover the entire front side of the template with 1 layer of duct tape. ,, Then trim the edges to fit the size of the template. , Wrap the duct tape covered template around the iPod and secure with another piece of duct tape on the back. ,,
3. 3

   Step 3: Cut the paper to the outermost measurements to fit the iPod.

4. 4

   Step 4: Put the iPod face down on the cut out paper and wrap it up.

5. 5

   Step 5: Turn over the wrapped iPod and trace the wheel and display.

6. 6

   Step 6: Lay the template flat.

7. 7

   Step 7: Turn the template over to the backside and repeat step 5 on the backside.

8. 8

   Step 8: Carefully cut out the holes for the display and wheel.

9. 9

   Step 9: Lay the iPod face down on the template and match up the cutout holes for the display and wheel.

10. 10

    Step 10: Carefully cut out the holes in the top and bottom flaps for the earphone plug and the power plug then secure both sides with duct tape.

11. 11

    Step 11: Now you have a finished case for your iPod.

Detailed Guide

About the Author