How to Replace Parts on the Nikon D
Remove the rear cover as described above. , Remove the main circuit board as described above. , Remove the 3 screws as indicated in the photo., Remove the sub-circuit board with sensor. , Replacing sensor., Install the main circuit board and rear...
Step-by-Step Guide
-
Step 1: Remove the rear cover as described above.
Carefully note the position of the sensor as it slides around a little when the screws are loosened.
This may affect image quality when re-installing. ,, Make sure the sensor is clean before installing.
Try to position the sensor as close as the original.
Install the 3 screws. , Remember to connect all solder wires and ribbon cables. -
Step 2: Remove the main circuit board as described above.
-
Step 3: Remove the 3 screws as indicated in the photo.
-
Step 4: Remove the sub-circuit board with sensor.
-
Step 5: Replacing sensor.
-
Step 6: Install the main circuit board and rear cover.
Detailed Guide
Carefully note the position of the sensor as it slides around a little when the screws are loosened.
This may affect image quality when re-installing. ,, Make sure the sensor is clean before installing.
Try to position the sensor as close as the original.
Install the 3 screws. , Remember to connect all solder wires and ribbon cables.
About the Author
Andrea Thompson
Andrea Thompson is an experienced writer with over 1 years of expertise in advertising. Passionate about sharing practical knowledge, Andrea creates easy-to-follow guides that help readers achieve their goals.
Rate This Guide
How helpful was this guide? Click to rate: